JACK STAND 6TON
Ref: 4856
Characteristics:
Capacity: 6 ton
Minimum height: 408mm
Maximum height: 600mm
Base dimension: 274x240mm
Operation:
1- Refer to your vehicle owner’s manual for proper jacking lift point. This area of the vehicle is specified by vehicle manufacturer
2- Positions stands under vehicle at points specified by vehicle manufacturer as proper load support points
3- To adjust stands hold control level up while lifting saddle just to desired height. Push the control lever down to lock pawl into teeth located in center column. Make sure pawl is fully engaged into teeth
4- Carefully lower load onto stands. WARNING! Set both jack stands to the same height
Maintenance and inspeciton
1- Visual inspection shall be made before using the stands. Check the cracked welds and missing and/or damaged parts. A stand that appears to be damaged must be removed from service immediately
2- Do not use jack stands as a long-term stand for the vehicle. Use them only while making repairs, then immediately lower vehicle to the ground
EXP: Unidades / Lojas:
